6 Turn the ADJUST knob to the right so that CHECK blinks on the
The test signal is output and the unit starts checking the status of the connection.
When the unit and the camcorder are connected correctly, the following window appears.
When the L/R MASTER level control of the unit or the REC level of the camcorder is not correctly adjusted, the following window appears.
Center marker
Shows that the | Shows that the |
level of the right | level of the left |
signal is shifted | signal is shifted |
away from the | away from the |
correct position. | correct position. |
The level of the return signal from the camcorder is lower.
The level of the return signal from the camcorder is higher.
In either case, the L/R MASTER level control of the unit or the REC level of the camcorder is not correctly adjusted.
Readjust the level so that the marker is located at the center, repeating steps 2 and 3, as necessary.
A message stating the result of the check also appears.
For detailed information on messages, see the following “Messages stating the results of check”, on page 37.
Note
This adjustment function of the return signal level is effective when a camcorder with a balanced output of 0 dBu is used.
7 Push the ADJUST menu.
The unit stops outputting the test signal and completes the check of the status of the connection.
To return to the setup menuTurn the ADJUST knob to the left until the return mark blinks, and then press the ADJUST knob.
36