2.SCENE STORE Sub- Menu

This sub-menu allows you to store ten different parameter settings as a scene file from scenes nos. 0 to 9. Recalling the desired scene changes the unit to the desired setup immediately.

Parameters stored in a scene file

Parameters set on sub-menus 4 to 11.

Note

For settings on the 10. PANEL LOCK sub-menu, only the locked switches and controls are stored. To actually lock those switches and controls, you should set the FUNCTION switch to the LOCK position.

Storing a scene

1 Turn the ADJUST knob until the

2.SCENE STORE sub-menu appears, and then press the ADJUST knob.

Status display section

2 Turn the ADJUST knob until the desired scene number blinks. Turning the ADJUST knob to the right changes the scene number in the following sequences: SCENE 0 t SCENE 1 t SCENE 2

......SCENE 8 t SCENE 9.

Turning the ADJUST knob to the left changes the scene number in the reverse order.

The status display section shows the status of each scene.

Display

Status

 

 

DEFAULT

The corresponding

 

scene file is not used

 

(parameters are default

 

settings).

 

 

STORED

The default settings are

 

overwritten (parameters

 

other than the defaults

 

are stored).

 

 

3 Press the ADJUST knob.

The cursor moves to the status display section and CANCEL appears there.

4 Turn the ADJUST knob to the right to display WRITE.

Turning the ADJUST knob to the right changes the status display section in the following sequence: CANCEL t WRITE t

ERASE.

To cancel the storing operation and return the cursor to the scene number selection area: Display CANCEL.

To reset the parameters to the default settings:

Display ERASE.

5 Press the ADJUST knob to execute the change.

Parameters currently set are stored as a scene with the number selected in step 2.

27