Digitally Dubbing Signals in DVCAM/DV Format

In addition to straightforward tape dubbing, you can also use this unit to dub signals in DVCAM/DV format automatically from the beginning of the tape to the end through the SDTI (QSDI) or i.LINK interface.

•To use the SDTI (QSDI) interface, the optional DSBK- 1501 board is required.

When a tape recorded on a DSR-1/1P Digital Videocassette Recorder or DSR-130/130P Digital Camcorder is dubbed, the ClipLink log data held in the cassette memory is also copied.

Notes

•It is not possible to dub signals recorded in DV (LP) format.

Digital dubbing is carried out in the digital format used on the source tape regardless of the recording format selected on this unit. If the source tape begins with a section in which no signals are recorded, the corresponding no-signal section created at the beginning of the tape recorded on this unit may have a different length depending on the digital format of the source tape, the recording format selected on this unit, etc. During dubbing, if the digital format of the source tape changes, no signals are recorded until the initial digital format is restored. No signals are recorded also when the digital format used on the player is DV (LP).

•Regardless of the audio recording mode setting of this unit, dubbing is performed with the original audio recording mode unchanged (two-channel/48 kHz mode or four-channel/32 kHz mode).

•Approximately the last 2 minutes of the tape may not be copied because of differences in tape lengths. (If an index picture is recorded in this portion, it may also not be copied.)

•A continuous recorded section of approximately 5 seconds is required before the recording start point. It is recommended to record beforehand color bars or a similar signal at the start point of the source tape to be dubbed on this unit.

Connections for dubbing via SDTI (QSDI) interface

To carry out dubbing through the SDTI (QSDI) interface, connect the REMOTE and SDTI (QSDI) IN/OUT connectors on this unit to those on the DSR-85/85P/70A/ 70AP/2000/2000P/1800/1800P/1600/1600P/1500A/ 1500AP.

For details of the connections and switch settings, see “Connections for SDTI (QSDI) Dubbing” on page 98.

Connections for dubbing via i.LINK interface

To carry out dubbing through the i.LINK interface, connect the i.DV IN/OUT connectors on this unit and the player.

Use the following procedure.

MENU

RESET(NO)

 

1,9

 

 

TC

 

 

PRESET

SET(YES)

 

 

7

 

2

3,4,5

 

 

 

 

2,4

 

1 Press the MENU button in the menu control section.

Chapter

 

 

3

AUTO FUNCTION

Setup menu

Convenient

SYSTEM MENU

 

SETUP MENU

 

HOURS METER

Time counter display

EditingforFunctions

 

Monitor screen

 

Operation

 

 

2 Press the f or F button to select “AUTO FUNCTION.”

SYSTEM MENU

 

Auto func

SETUP MENU

 

 

 

 

AUTO FUNCTION

 

Time counter display

HOURS METER

 

 

 

 

 

 

Monitor screen

Digitally Dubbing Signals in DVCAM/DV Format 59