Sony GDM-5510 operating instructions If OUT of Scan Range appears on line

If OUT OF SCAN RANGE appears on line 1

This indicates that the input signal is not supported by the monitor’s specifications.

I NFORMAT I ON

MONI TOR		I S WORK I NG
	I NPUT	1 : 2 0 0 . 0 k H z / 85Hz
	OUT OF	SCAN RANGE
		S I GNAL T I M I NG
	CHANGE

W

R G B

2The selected connector and the frequencies of the current input signal

This message shows the currently selected connector (INPUT 1 or INPUT 2). If the monitor recognizes the frequencies of the current input signal, the horizontal and vertical frequencies are also displayed.

3The remedies

CHANGE SIGNAL TIMING appears on the screen. If you are replacing an old monitor with this monitor, reconnect the old monitor. Then adjust the computer’s graphics board so that the horizontal frequency is between 30 – 130 kHz and the vertical frequency is between 48 - 170 Hz.

For more information, see “Trouble symptoms and remedies” on page 17.

EN

Displaying this monitor’s name, serial number, and date of manufacture.

While the monitor is receiving a video signal, press and hold the MENU button for more than 5 seconds to display this monitor’s information box.

MENU

Example

INFORMATION

MODEL : GDM	5510	W
SER NO : 1234567		R
MANUFACTURED : 2001-52		G
		B

If the problem persists, call your service representative and give the following information.

•Model name: GDM-5510

•Serial number

•Name and specifications of your computer and graphics board.

16