Checking recordings – End search/Edit search/Rec Review

If the tape has a blank portion between recorded portions

End search may not work correctly.

Edit search

You can search for the next recording start point. You cannot monitor the sound.

(1) Set the POWER switch to CAMERA.

(2) Press FN to display PAGE1.

(3) Press MENU to display the menu.

(4) Select EDITSEARCH in , then press EXEC (p. 127).

(5) Select ON, then press EXIT.

(6) Hold down 7/– or +. The recorded portion is played back.

Release 7/– or + to stop playback. If you press REC START/STOP, recording begins from the point you released 7/– or +.

7/– : To go backward + : To go forward

Rec Review

You can check the last recorded section.

(1) Set the POWER switch to CAMERA.

(2) Press FN to display PAGE1.

(3) Press MENU to display the menu.

(4) Select EDITSEARCH in , then press EXEC (p. 127).

(5) Select ON, then press EXIT.

(6) Press 7/– momentarily.

The section you have stopped most recently will be played back for a few seconds, and then your camcorder will return to standby.

Contrôle de prises de vue – End search/Edit search/Rec Review

S’il y a une section vierge entre deux sections enregistrées sur une cassette La fonction de recherche de fin peut ne pas fonctionner pas correctement.

Edit search (recherche pourmodification)

Vous pouvez rechercher le point de départ de l’enregistrement suivant. Vous ne pouvez pas contrôler le son.

(1) Réglez le commutateur POWER sur

CAMERA.

(2) Appuyez sur FN pour afficher PAGE1.

(3)Appuyez sur MENU pour afficher le menu.

(4) Sélectionnez EDITSEARCH sous , puis appuyez sur EXEC (p. 135).

(5) Sélectionnez ON, puis appuyez sur EXIT.

(6) Maintenez la touche 7/– ou + enfoncée. La portion enregistrée est lue. Pour arrêter la lecture, relâchez 7/– ou +. Si vous appuyez sur REC START/ STOP, l’enregistrement recommence du point où vous avez relâché 7/– ou +. 7/– : Pour lire vers l’arrière

+ : Pour lire vers l’avant

Rec Review (vérificationd’enregistrement)

Vous pouvez vérifier la dernière partie enregistrée.

(1) Réglez le commutateur POWER sur

CAMERA.

(2) Appuyez sur FN pour afficher PAGE1.

(3) Appuyez sur MENU pour afficher le menu.

(4) Sélectionnez EDITSEARCH sous , puis appuyez sur EXEC (p. 135).

(5) Sélectionnez ON, puis appuyez sur EXIT.

(6) Appuyez brièvement sur 7/–.

La section sur laquelle vous vous êtes arrêté en dernier est lue pendant quelques secondes, puis le caméscope repasse en mode d’attente.

base de Opérations – Enregistrement Basics – Recording

45