Identifying parts and controls

To prepare the RemoteCommander

Insert 2 R6 (size AA) batteries by matching the

+and – on the batteries to the + and – in the battery compartment.

Notes on the Remote Commander

•Point the remote sensor away from strong light sources such as direct sunlight or overhead lighting. Otherwise, the Remote Commander may not function properly. •Your camcorder works in the Commander

mode VTR 2. Commander modes 1, 2 and 3 are used to distinguish your camcorder from other Sony VCRs to avoid erroneous remote control operation. If you use another Sony VCR in the Commander mode VTR 2, we recommend changing the Commander mode or covering the sensor of the VCR with black paper.

Identification des composants et des commandes

Pour préparer la télécommande

Insérez 2 piles R6 (AA) en faisant correspondre les pôles + et – des piles avec les inscriptions à l’intérieur du logement de piles.

Remarques sur la télécommande

•Le capteur de télécommande ne doit pas être orienté vers de fortes sources lumineuses telles que la lumière directe du soleil ou la lumière de lampes de plafond. Sinon, la télécommande pourrait ne pas fonctionner correctement.

•Votre caméscope fonctionne en mode de télécommande VTR 2. Les modes de télécommande 1, 2 et 3 sont utilisés pour distinguer votre caméscope des autres magnétoscopes Sony afin d’éviter que le fonctionnement des appareils ne soit déclenché accidentellement. Si vous utilisez un autre magnétoscope Sony fonctionnant avec le mode de télécommande VTR 2, nous recommandons de modifier le mode de la télécommande ou de masquer le capteur du magnétoscope avec du papier noir.

190