6 Pull the section with belts located inside the printer up slowly and remove the paper jammed between the openings.

9 Re-insert the auto sheet feeder tray.

10 Pull out the output support completely.

If it is pulled out halfway, the paper may jam again.

Pull this section up slowly.

If you can remove the jammed paper, go to step 8. When the edge of the jammed paper can not be seen, go to step 7.

7 Roll the green roller back and forth so that the jammed paper comes out. Then remove it slowly.

Miscellaneous

Note

Be careful not to touch any parts except the green roller.

8 Reset the section with the belts as it was, after you have removed the jammed paper, and then close the main cover.

Note

When resetting the section with belts, be sure to put the shaft located at the front of the section into the center groove. If you put the shaft into the wrong groove, the printer may break.

58 Error Messages