Basic Operations

When “TOC Writing” flashes in the display

The deck is currently updating the Table Of Contents (TOC). Do not move the deck or pull out the AC power cord. Changes to an MD made through recording are saved only when you update the TOC by ejecting the MD or changing the deck to standby by pressing the 1/uswitch.

10EN

6

Press rREC.

The deck becomes ready to record.

 

 

7

Adjust the recording level.

 

When recording through the DIGITAL COAXIAL IN, OPTICAL IN1, or

 

IN2 connector

 

Adjust the outer REC LEVEL (DIGITAL) control so that the

 

peak level meter in the display is a maximum of 0 dB. For

 

details, see page 15.

 

When recording through the LINE (ANALOG) IN jacks

 

Setting the inner REC LEVEL (ANALOG) control at 4 is

 

satisfactory for most purposes. For details, see page 15.

 

 

8

Press · or P.

Recording starts.

 

 

9

Start playing the program source.

 

 

Do not disconnect the deck from the power source immediately after recording

If you do, recorded material may not be saved to the MD. To save the material, after recording, press §EJECT to take out the MD or change the deck to standby by pressing 1 /u . “TOC Writing” will flash in the display at this time.

After “TOC Writing” stops flashing and goes out, you can pull out the AC power cord.

To

Press

 

 

Stop recording

p

 

 

Pause recording*

P. Press the button again or press ·to resume

 

recording.

 

 

Take out the MD

§EJECT after stopping

 

 

*Whenever you pause recording, the track number increases by one. For example, if you paused recording while recording on track 4, the track number increases by one and recording continues on the new track when restarted.

To protect an MD against accidental erasure

To make it impossible to record on an MD, slide the tab in the direction of arrow, opening the slot. To allow recording, close the slot.

Record-protect tab

Rear of the disc Slide the tab in the

direction of arrow