Additional Information
“TOC Reading” appears for a long time
If the inserted recordable MD is brand new, “TOC Reading” appears in the display longer than for MDs that have been used.
Limitations when recording over an existing track
•The correct remaining recording time may not be displayed.
•You may find it impossible to record over a track if that track has been recorded over several times already. If this happens, erase the track using the Erase Function (see page 39).
•The remaining recording time may be shortened out of proportion to the total recorded time.
•Recording over a track to eliminate noise is not recommended since this may shorten the duration of the track.
•You may find it impossible to label a track while recording over it.
The correct recorded/playing time may not be displayed during playback of
If you experience any of the following difficulties while using the deck, use this troubleshooting guide to help you remedy the problem. Should any problem persist, consult your nearest Sony dealer.
The deck does not operate or operates poorly.
/The MD may be damaged (“Disc Error” appears). Take the MD out and insert it again. If “Disc Error” remains, replace the MD.
The deck does not play back.
/Moisture has formed inside the deck. Take the MD out and leave the deck in a warm place for several hours until the moisture evaporates.
/The deck is not on. Press 1/uto turn the deck on.
/The MD is inserted in the wrong direction. Slide the MD into the disc slot with the label side up and the arrow pointing towards the opening.
/The MD may not be recorded (the music calendar does not appear). Replace the disc with one that has been recorded.
The deck does not record.
/The MD is
Close the
/The deck is not connected properly to the sound source. Make connections properly to the sound source.
/The recording level is not adjusted properly. Adjust the recording level properly (see page 15).
/A premastered MD is inserted. Replace it with a recordable MD.
/There is not enough time left on the MD. Replace it with another recordable MD with fewer recorded tracks, or erase unnecessary tracks.
/There has been a power failure or the AC power cord has been disconnected during recording. Data recorded to that point may be lost. Repeat the recording procedure.
The deck does not work during
/The currently selected CD player type (CD player or video CD player) does not match the CD player being used. Reset the CD player type (see page 19).
If the CD player being used has a mode selector, set the selector to CD1.
You cannot use the Mega CD Control Function.
/The control A1 cable is not connected properly. Insert the plugs firmly.
/Set the CD mode selector to CD1.
/The deck is not recognizing the connected CD changer. Turn the deck and CD changer off and on, and then reset the Mega CD Control mode.
The sound has a lot of static.
/Strong magnetism from a television or a similar device is interfering with operations. Move the deck away from the source of strong magnetism.
The
/The
Note
If the deck does not operate properly even after you’ve attempted the prescribed remedies, turn off the deck, then reinsert the plug into the power outlet.