Recording on MDs

Adjusting the Recording Level

You can adjust the recording level before starting recording.

REC LEVEL

MENU/NO (DIGITAL/ANALOG)

0 ) r

§

· P p

￿ AMS ±

U 16 V 17 W 18 X 19 Y 20

Z21 – 22 23 . 24 , 25

REPEAT A˜B A.SPACE M.SCAN

/>25 ? ! ( )

WRITE

 

CLEAR P.HOLD

P. HOLD

NAME CHAR

NUM

 

 

·P p

REC-IT

=+ r

T.REC MUSIC SYNC

0)

CD-SYNC

STOP START STANDBY

CD PLAYERFADER

DIGITAL REC LEVEL

P = +

 

/ANALOG OUT LEVEL/ANALOG OUT LEVEL +/–

DIGITAL REC LEVEL

 

Adjusting the digital recording level

You do not normally need to adjust the digital recording level. The level is adjusted mainly when the level of the source is low.

1Do Steps 1 to 6 in “Recording on an MD” on pages 9 and 10.

2Play the portion of the program source with the strongest signal level.

3While monitoring the sound, turn outer REC LEVEL (DIGITAL) (or press DIGITAL REC LEVEL/ANALOG OUT LEVEL +/–) to adjust the recording level so that the peak level meters reach their highest point without turning on the OVER indication. Occasional lighting of “OVER” is acceptable.

OVER indication

If the digital signal level of the source is too low, it may not be possible to set the recording level to maximum.

4Stop playing the program source.

5To start recording, do the procedure starting from Step 8 in “Recording on an MD” on page 10.

zThe Peak Hold Function freezes the level meter display at the highest level reached by the input signal

To turn on the Peak Hold Function by Setup Menu 06 setting

1While the deck is stopped, press MENU/NO twice to display “Setup Menu”.

2Turn AMS to select “Setup 06”, then press AMS.

3Turn AMS to select “P.Hold On”, then press AMS.

4Press MENU/NO.

To turn on the Peak Hold Function using the remote

Press P.HOLD to display “P.Hold On.”

To turn off the Peak Hold Function, select “P.Hold Off” in Step 3 above. (Or press P.HOLD on the remote to display “P.Hold Off”.)

Adjusting the analog recording level

1Do Steps 1 to 6 in “Recording on an MD” on pages 9 and 10.

2Play the portion of the program source with the strongest signal level.

3While monitoring the sound, turn inner REC LEVEL (ANALOG) to adjust the recording level. If the output level of the connected component is too low, it may not be possible to set the recording level to maximum.

4Stop playing the program source.

5To start recording, do the procedure starting from Step 8 in “Recording on an MD” on page 10.

15EN