Sony SX-MT321 Additional Dolby PRO Logic Modes, ~ UP on the remote control to adjust the volume

				MANUAL
				SELECT
				2
				1
u	. .		IT	<DOWN,
	—.r
r=!-— ,—.				*UP
		—
,—— —.			4

-a u

1 Press VIDEO/AUX and start playback of the video source.

“VIDEO is displayed.

2 Press DOLBY PRO LOGIC.

“NORMAL” is selected, and the playback sound has the DOLBY PRO LOGIC effect.

To cancel DOLBY PRO LOGIC mode

Press DOLBY PRO LOGIC repeatedly until “PRO-OFF is displayed.

To change the sound levels during playback

After adjusting the balance with the noise sequencer, the sound levels of the center or each surround speaker can be adjusted during playback of laser discs or video software.

1 Press MANUAL SELECT (TEST) on the remote control repeatedly to select “CEN” (center speaker) or “SUR”

(surround speakers).

2While the “CEN”or “SUR”is displayed, press ~ DOWN or

~UP on the remote control to adjust the volume.

..... l~...’,’’!”,’! ,! ’,!,>..! :-- .. ‘v,’ ‘)!,,,,’”!’ ! ., :-.-Y t.+ ‘!s7,. -,.:.!”,’ : --- @ “: % .Sw .

ADDITIONAL DOLBY PRO LOGIC MODES

In addition to the NORMAL mode, this unit is also e~uipped with the PHANTOM and the 3 STEREO modes,

PHANTOM mode: Use this mode when no center speaker is connected. The center channel signals are output through the left and right speakers.

3 STEREO mode: Use this mode when no surround speakers are connected. This mode reproduces rear sounds through tha front speakers.

To select PHANTOM or 3 STEREO

Press DOLBY PRO LOGIC repeatedly until the desired DOLBY PRO LOGIC mode is displayed. The DOLBY PRO LOGIC mode is displayed cyclically as follows.

~ NORMAL ---+ PHANTOM+ 3 STEREO ~

~PRO-OFF (cancel) ~

To adjust the balance of connected speaker sound levels Carry out steps 2 to 4 of “ADJUSTING SPEAKER LEVEL BALANCE”.

●Depending on the sound source and/or listening conditions, a surround effect may not be obtained even when the DIOLB~ PRO LOGIC is on.

●The full DOLBY PRO LOGIC effect cannot be obtained when using software without lltl WBVSURROUND[mark.

●The DOLBY PRO LOGIC is automatically canceled when the headphones are plugged in.

●Set the microphone volume to OFF while the DOLBY PRO LOGIC is on. Otherwise, the DOLBY PRO LOGIC sound can not be reproduced correctly.

g

J

%

~~-,,

.,,-,

W%T $;~.

!j&~

‘:J!p:

“~

O

Q

ENGLISH18