Sony NSX-MT320 manual 1,2,3 2,3, Connect your microphone to MIC jack, minute, then press 11 SET

m

A microphone (not supplied) can be connected to this unit, allowing you to sing along to music sources.

Use a microphone with a mini plug (03.5 mm, 1/6inch).

1 Connect your microphone to MIC jack.

Ic

2 Press one of the function buttons to select the

source to be mixed, and play the source.

3 Adjust the volume and tone of the source.

4 Press MIC and turn VOLUME within 4 seconds to adjust the microphone volume.

The microphone volume can be selected from 1 to MAX (7) or OFF (cancel).

The volume of both microphones is adjusted simultaneously.

To record microphone sound mixed with source sound

Follow the procedure for recording from the sound source (see page 13),

SYNC DUBBING cannot be used for mixing recording.

When not using the microphone

Set the microphone volume to OFF and remove the microphone from MIC jack.

s If a microphone is held too near the speakers, a howling sound may be produced, In this case, hold the microphone away from the speakers, or decrease the microphone volume.

●If sound through the microphone is extremely loud, it may be distorted. In this case, decrease the microphone volume.

●When the function is changed, the microphone volume is set to off.

Recommended microphones

The use of unidirectional type microphones is recommended to

prevent howling, Contact your local Aiwa dealer for details.

■1,2,3

2,3

1

1 Press CLOCIVDIMMER ~, then press II SET within 4 seconds.

2 Press < DOWN or - UP to designate the hour, then press II SET.

The hour stops flashing and the minute starts flashing.

3 Press 4+ DOWN or - UP to designate the

—

minute, then press 11 SET.

The minute stops flashing on the display and the clock starts from 00 seconds.

To display the current time

Press CLOCK. The time is displayed for 4 seconds. However, the time cannot be displayed during recording.

To switch to the 24-hour standard

Press CLOCK and then press ■ within 4 seconds.

Repeat the same procedure to restore the 12-hour standard.

If the clock display flashes

This is caused by a power interruption. The current time needs to be reset.

If power is interrupted for more than approximately 24 hours, all settings stored in memory after purchase need to be reset.

* MULTI JOG is also available instead of 4+ and FF.

I 9 ENGLISH