Location and Function of Parts and Controls

5Y/C button

Selects the signal input from the Y/C IN jack in the LINE connectors.

6Number buttons

Press to select the index number.

7ZOOM button

Each time you press this button, the image size changes (in order) to double (⋅2), triple (⋅3), quadruple (⋅4) and original size.

8STILL button

This button does not operate with the monitor.

9POWER ON switch

Press to turn on the monitor. When you use multiple monitors, you can use this switch instead of the POWER switch 1 so as not to affect another monitor which may be already turned on.

0POWER OFF switch

Press to turn the monitor to the standby mode. When you use multiple monitors, you can use this switch instead of the POWER switch 1 so as not to affect another monitor which may be in the standby mode.

qa ID MODE (ON/SET/OFF) buttons

Press the ON button to make an index number appear on the screen. Then press the index number of the monitor you want to operate and press the SET button. After you finish the operation, press the OFF button to return to the normal mode.

qs DISPLAY button

Displays the input signal information and the time at the top of the monitor screen. Press again to clear it.

qd YUV button

Selects the component signal input from the RGB1 connectors.

qf MTS/MPX button

This button does not operate with the monitor.

qg CH button

This button does not operate with the monitor.

qh DEGAUSS button

This button does not operate with the monitor.

qj SELECT +M/–mbuttons

Press to move the cursor (B) to an item or to adjust a value in a menu.

qk MENU button

Press to make the menu appear.

ql ENTER button

Press to select the desired item in a menu.

w; VOL +/– buttons

Press the + button to increase the volume, or the – button to decrease the volume.

wa CH +/– buttons

This button does not operate with the monitor.

Installing batteries

Insert two size AA (R6) batteries in correct polarity.

Be sure to install the negative <– end first.

E e

e

E

•In normal operation, batteries will last up to half a year. If the Remote Commander does not operate properly, the batteries might be exhausted sooner. Replace them with new ones.

•To avoid damage from possible battery leakage, remove the batteries if you do not plan to use the Remote Commander for a fairly long time.

When the Remote Commander does not work

Check that the 1 indicator lights up. The Remote Commander operates the monitor only when the monitor is turned on, or it is in the standby mode.

Note

When you use multiple monitors, if you connect the cable to the CONTROL S IN jack on the side of the monitor, you cannot operate the monitor with the Remote Commander.

12 (GB)