Location and Function of Parts and Controls
Control Panel
VOL – |
| VOL + |
| MENU |
| m |
| M |
| ENT |
| RGB1 |
| YUV |
| RGB2 |
| LINE |
| Y/C |
| CTRL |
| 1 |
qd | qs | qa | 0 | 9 8 7 6 5 | 4 3 2 1 |
1Remote control detector
Receives the beam from the Remote Commander.
21 (standby) switch/1 (standby) indicator Press to turn on the monitor. Press again to go back to the standby mode.
The 1 (standby) indicator lights up in red in the standby mode.
When the 1 indicator flashes, see
3Power indicator
Lights up when the monitor is turned on.
4CTRL (control) button
To operate the buttons on the control panel, first press this button. When the buttons light up or flash that shows that they can be operated. Press again to deactivate them.
Note
The buttons (except for 1 (standby) switch 2) on the control panel do not function if you do not press the CTRL button first.
5Y/C button
Selects the signal input from the Y/C IN jack among the LINE connectors.
6LINE button
Selects the signal input from the VIDEO IN connector among the LINE connectors.
7RGB2 button
Selects the signal input from the RGB2 connectors.
8YUV button
Selects the component signal input from the RGB1 connectors.
9RGB1 button
Selects the RGB signal input from the RGB1 connectors.
0ENT (enter) button
Press to select the desired item from the menu displayed.
qa M/m buttons
Press to move the cursor (B) to an item or to adjust a value in a menu.
qs MENU button
Press to make the menu appear.
qd VOL (volume) +/– buttons
Press the + button to increase the volume, or the – button to decrease the volume.
8 (GB)