Self-diagnosis Function / Operating a Specific Monitor With the Remote Commander

Self-diagnosis Function

The unit has a self-diagnosis function.

This function displays the monitor’s condition with the 1 indicator flashing and numbers on the SERVICE CODE indicator on the left connector panel. The numbers inform you of the monitor’s current condition.

When the unit is working properly, only the dot at the lower-right position on the SERVICE CODE indicator flashes.

If the 1 indicator flashes, check the number and contact your authorized Sony dealer.

1 Check the two-digit number on the SERVICE CODE indicator.

The indicator shows one number, or multiple numbers alternately in one second intervals.

2 Unplug the unit.

Inform your authorized Sony dealer of the number.

Operating a Specific Monitor With the Remote Commander

Using the supplied Remote Commander, you can operate a specific monitor without affecting other monitors that are installed at the same time.

1 Press ID MODE ON on the Remote Commander. Monitor index numbers appear in white characters on all the monitors. (Every monitor is allocated an individual preset index number from 1 to 255.)

See “To change the index number” in the left-hand column on the next page to change the index number.

Index number

ON

I N D E X N o . 1 1 7 . . .

2 Input the index number of the monitor you want to operate using the 0 – 9 buttons on the Remote Commander.

The input number appears right next to the index number of each monitor.

Input number

I N D E X N o . 1 1 7 1 1 7

1 2 3

4 5 6

7 8 9

10/0

3 Press ID MODE SET.

The character on the selected monitor changes to cyan while others change to red.

ON

SET

OFF

ID MODE

You can operate only the monitor specified. (All operations are available in ID mode except POWER ON/OFF.)

4 After the necessary adjustment, press ID MODE OFF.

The monitor returns to the normal mode.

ON

SET

OFF

ID MODE

SET

OFF

ID MODE

36 (GB)