Broadcasts Receiving
Preset Tuning
For details on the buttons used in this section, see “Brief descriptions of buttons used to receive broadcasts” on page 42.
Before tuning to preset stations, be sure to preset them by performing steps on “Presetting radio stations” below.
Presetting radio stations1Rotate FUNCTION to select the tuner.
The last received station is tuned in.
2Tune in the station that you want to preset using Direct Tuning (page 43)‚ or Automatic Tuning (page 43).
3Press MEMORY.“MEMORY” appears in the display for a few seconds. Do Steps 4 to 6 before “MEMORY” goes out.
4Press SHIFT to select a memory page (A, B or C).Each time you press SHIFT, the letter “A,” “B” or “C” appears in the display.5Select a preset number by pressing PRESET TUNING + or PRESET TUNINGNote
If the AC power cord is disconnected for about two weeks, all the preset stations will be cleared from the receiver’s memory, and you will have to preset the stations again.
1Rotate FUNCTION to select the tuner.
The last received station is tuned in.
2Press PRESET TUNING + or PRESET TUNING – repeatedly to select the preset station you want.
Each time you press the button, the receiver tunes in one preset station at a time, in the corresponding order and direction as follows:
nA1˜A2˜...˜A0˜B1˜B2˜...˜B0N
nC0˜...C2˜C1N
zYou can scan the preset stations by program typeSee page 45.
Using the preset codesUse the supplied remote to perform the following operations.
For details on the buttons used in this section, see the operating instructions for the supplied remote.
1Select the tuner using the supplied remote.The last received station is tuned in.
2Press SHIFT to select a memory page (A, B or C), then press the preset number of the station you want using the numeric buttons on the supplied remote.