Setting up the 2 way remote

(STR-DB930 only)

This receiver is shipped from the factory with the 2 way remote control system set to “ON.” Normally, you can use the receiver as is.

However, if you want to use this receiver together with another component that is also compatible with the 2 way remote control system, be sure to perform the following operation to limit response to signals sent from the remote controls.

To use with the TA-E9000ES

Perform the following steps to turn OFF this unit’s 2 way remote control system. Also, be sure the TA-E9000ES is turned on when using this unit.

To use with other components that have the logo

Turn OFF the other component’s 2 way remote control system. For details, refer to the operating instructions suppled with your other components.

To use with Sony CD players CDP-CX260 or CDP-CX88ES

Turn OFF the remote control adapter switch on the CDP-CX260 or CDP-CX88ES. For details, refer to the operating instructions suppled with the CDP-CX260 or CDP-CX88ES.

Also when using several 2 way remote control system components together, be sure to place them close together in order to enable proper remote operation.

1Press SET UP.

2Press the cursor buttons ( or ) to select “2 WAY REMOTE.”

3Turn the jog dial to select “ON” or “OFF.”

Operations Other

51GB