The film tray is partially ejected.

Operation

Loading Film

Recommended Film

The following blue thermal film is made especially for the UP-DF500.

UPT-517BL Blue Thermal Film printing pack Contains blue thermal transparent film.

125 sheets of 14 × 17 inch film

Be sure to use film made expressly for the UP-DF500. If you use other film, the quality of the printout cannot be guaranteed. Use of another type of film may also cause malfunction of the unit.

Loading Film

Proceed as follows to load film sheets.

If you use the unit immediately after purchase, start operations from step 2.

To confirm the remaining amount of film

The remaining film confirmation indicator allows you to confirm the amount of film remaining.

When this indicator is not lit, film has run out. Load new film.

Remaining film confirmation window

Notes

•Hold the film using the aluminum damp-proof bag. Do not touch the film directly. Dust, finger prints, or sweat are likely to cause unsatisfactory printing.

•Hold both sides of the film tray and tray cover tightly when handling the film tray.

1 Push the EJECT TRAY button on the front panel.

Push the EJECT TRAY button

Notes

•You can replace film without pulling out the film tray completely out. However, if you want to pull out it completely, hold both sides of the film tray and film tray cover firmly.

•The film tray can not be ejected while printing or when the covers are open.

2 Open the film tray cover by putting your fingers in

the grooves on both sides of the film tray, and pulling it upward in the direction of the arrow.

Pull it upward in the direction of the arrow, putting your fingers in the grooves.

Note

If the old printing surface protection sheet remains in the film tray, remove it.

3 Remove the aluminum damp-proof bag from the film carton.

Operation

Loading Film 11