When placing the unit vertically

You can place the unit vertically if you attach the casters provided. This is convenient for placing the unit under a desk and to pull it out easily.

Connections

Connect the unit to the 100BASE-TX LAN.

Notes

•Connect the AC power cord last.

•Before connecting to the LAN, be sure to set up the required IP address and sub-net mask.

For detailed information, consult the system administrator.

•Before connecting the unit using a 100BASE-TX cable, attach the ferrite cores provided to both ends of the cable for noise prevention.

For detailed information on how to attach the ferrite cores, see “How to attach the ferrite cores” (on page 10)

Preparation

Fix the unit using the front caster.

Stopper sheet

Fix the front caster using the stopper sheet (supplied).

Be sure to place the roller of the caster in the groove of the stopper sheet.

Notes

•Ask your nearest Sony dealer to attach the casters to the unit.

•Use the casters to allow the unit to be pulled out from under the desk and so on. Be sure not to use the casters for moving the unit on an uneven surface.

•Place the stopper sheet (supplied) under a unit with casters attached.

•When pulling the unit in and out while the unit is equipped with the casters provided, be careful not to damage the power cord, LAN cable, and so on.

•When placing the unit vertically, make sure the LCD is near the floor, and leave a space of more than 8 cm (3 1/4 inches) between the top of the unit and the subject to prevent blocking the ventilation holes.

to the network connector

to- AC IN

 

100BASE-TX cable a)

 

Power cord (supplied)

to the LAN

a)Be sure to use a network cable of less than 30 m in length, and rated more than category 5.

Connections 9