When film is running short: Lights in yellow.

When film has been exhausted: Goes off. The ALARM indicator lights in orange and the message is displayed in the LCD.

CPRINT indicator (14, 26)

Lights in green while the printer is printing.

DALARM indicator (25)

Lights in orange when the film has been used up, film jams occur, or other problems occur.

ETOP cover (28)

Open when removing jammed film.

FVentilation holes (23)

There is a built-in fan to prevent the thermal head from overheating.

GEJECT TRAY button (11)

Push this button to pull the film tray out. This button activates when the power is on and all covers are closed.

HFilm output slot (14)

Printed film sheets (printouts) are ejected here.

IFilm tray (8, 11)

Load film sheet into this tray. Also, ejected film sheets accumulate on this tray.

JFront cover lock lever (21, 22) Used to open the front cover.

KFront cover (21, 28)

Open when the thermal head and rollers are being cleaned. Also open when jammed film is being removed.

LON/STANDBY switch/indicator (14, 26) Press this switch to set the unit to on or to the standby status. When the power is on, the indicator lights in green. When the this switch is set to STANDBY, the indicator blinks, and then goes off. Pressing this switch while the indicator is blinking turns the power back on.

Note

If the main POWER switch on the rear panel is not set to on, the power is not on even though the ON/ STANDBY switch on the front panel is set to on.

MEXEC button (16, 17)

Use this button in menu operations.

NG, g, F, f (Cursor control) buttons (15, 16, 17, 19)

Press these buttons to increase or decrease the setting values. Also press these buttons to select menu items.

OMENU button (15, 16, 17, 19)

Press these buttons to display menus on the printer window display. Also press these buttons to return to the normal window.

PRear cover (28)

Open this cover when removing jammed film.

QNetwork connector (RJ-45 modular jack) (9) Conforms to the 100BASE-TX standard. Used to connect to the LAN.

When using a LAN cable: For safety, do not connect to the connector for peripheral device wiring that might have excessive voltage.

RSpecial output connector Not used. For future use.

SCable stopper

Fixes the network cable to prevent it from being disconnected.

T-AC IN connector (9)

Used to connect the unit to a wall outlet with the supplied power cable.

UMain POWER switch

Main power switch of the unit. Turns the unit on or off. When this switch is set to on, the unit power is on when the ON/STANDBY switch on the front panel is set to on.

V Equipotential ground terminal connector Used to connect to a ground (equipotential) plug to bring the various parts of the system to the same potential.

Refer to “Important safeguards/notices for use in the medical environments” (on page 2)

Introduction

Location and Function of Parts and Controls

7