To replace the cleaning roller

The supplied cleaning kit contains the cleaning rollers (for replacement) and wet pads.

Proceed as follows to replace the cleaning roller with a new one.

1 Pull the lever toward you to open the front cover.

3 Remove the packing film on the new cleaning roller and attach a new cleaning roller.

2 Hold the left side of the cleaning roller and remove it by sliding it toward the right.

Cleaning roller

Insert the right side of the cleaning roller and push it toward the right. Then push the left side of the cleaning roller until it is locked.

Notes

•Be careful not to scratch the surface of the cleaning roller and not to drop it.

•Do not wipe the surface of the cleaning roller with the supplied wet pad.

4 Close the front cover completely.

If you continue the cleaning of the thermal head, platen roller, pinch roller and separation rubber, it is not necessary to close the front cover. Go to step 2 of the “To clean the thermal head, platen roller, pinch roller, and separation rubbers” (on page 21)

Note

When you close the cover, be careful not to catch your fingers or hand with the front cover.

To clean the thermal head, platen roller, pinch roller, and separation rubbers

Proceed as follows to perform the following cleaning tasks with the supplied wet pad.

Miscellaneous

Precautions 21