Sony UP-DF500 When setting up an E-mail, When the image data is not sent, After all of settings have been completed

Connect the UP-DF500 to the network. Turn on the power of the UP-DF500.

Setup

3 Perform the settings related to e-mail.

Mail Server IP Address text box

User ID text box

From text box

Send to text box

Enter addresses in the corresponding text boxes.

Enter item	Content
Mail Server IP	IP address of the mail server a)
Address
User ID	User ID
From	Return address of the E-mail
	notification when an error occurs and
	an e-mail message is sent.
Send to	Destination address of the E-mail.

a)Use only numerical characters for the IP address.

4 Click the [Save settings] button. The settings are saved.

Confirmation After Setup

After all of settings have been completed

Turn off the power of the UP-DF500 and disconnect the UP-DF500 and the personal computer for setup. Proceed as follows to confirm the operation of the UP- DF500.

1

2

3 Insert a film tray in which film sheets have been loaded.

4 Send the image data from a modality. The unit starts printing.

When the image data is not sent

Check whether or not the IP address of the modality side is correct.

When setting up an E-mail

Confirm the settings for an E-mail as follows.

1 Click E-mail settings in the page selection area to open the E-mail settings page.

When this page is opened after E-mail settings have been completed, the Send a test E-Mail button appears.

2 Click the [Send a test E-Mail] button.

A test e-mail message is sent if settings have been correctly performed.

Send a test E-Mail button

38 Confirmation After Setup