1 PressTUNER/BAND to select the FM or AM band.

When TUNER/BAND is pressed while the power is off, the power is turned on directly (Direct Play Function).

To select a band with the remote control

Press BAND while pressing SHIFT.

2 Press TUNER PRESET repeatedly to select the manual tuning mode.

Each time the button is pressed, the following three tuning modes are selected cyclically.

0Preset tuning mode: The preset number flashes.

@Auto search mode: “SEARCH”is displayed.

@Manual tuning mode: “SEARCH” is not displayed and the preset number does not flash.

Frequency SEARCH

Pres& number

m

The preset tuning mode is skipped if no station is preset.

3 Turn MULTI JOG clockwise or counter-clockwise to tune into a station.

The frequency changes as you turn MULTI JOG. When a station is received, “TUNE”is displayed for 2 seconds. During FM stereo reception, [[1011] is displayed.

((1011)

●44 DOWN and -UPare also available to tune in to a station.

To search for a station quickly (Auto Search)

Press TUNER PRESET repeatedly to display “SEARCH”(auto search mode), and turn MULTI JOG clockwise or counterclockwise until the frequency starts to change rapidly. After tuning in to a station, the search stops.

SEARCH

To stop the Auto Search manually, turn MULTI JOG a little in either direction.

c The Auto Search may not stop at the stations with very weak signals.

●++ DOWN and -UP are also available to search for a

station. Keep + DOWN or -UP pressed until the tuner starts searching. Press the button to stop the search manually.

When an FM stereo broadcast contains noise

Press MONOTUNER on the remote control while pressing SHIFT so that “MONO”appears on the display.

Noise is reduced, although reception is monaural.

To restore stereo reception, press MONO TUNER on the remote control while pressing SHIFT so that “MONO”disappears.

To change the AM tuning interval

The default setting of the AM tuning interval is 10 kHz/step. If you use this unit in an area where the frequency allocation system is 9 kHz/step, change the tuning interval.

Press POWER while pressing E on the unit. To reset the interval, repeat this procedure.

m

When the AM tuning interval is changed, all preset stations are cleared. The preset stations have to be set again.

I () ENGLISH