~

When the clock is set, the “:”between the hours and minutes flashes. When the clock setting is canceled due to a power failure, the entire clock display flashes.

1 Press Il.

When using the remote control, press CLOCK while pressing

2 Within 4 seconds, turn MULTI JOG to designate the hour and the minute.

Turning MULTI JOG changes both the hour and the minute.

4or - is also available instead of MULTI JOG. Holding these buttons down will vary the time rapidly.

3 Press ENTER or II.

The clock starts from 00 seconds

To view the clock when another display is in the display

Press CLOCK while pressing SHIFT. The time is displayed for 4 seconds and then the original display reappears. However, the clock cannot be displayed during recording.

To switch to the 24-hour standard

Press II and then press ■ within 4 seconds.

Repeat the same procedure to restore the 12-hour standard.

If the clock display flashes

If the display flashes when the clock is displayed, it indicates that the clock has stopped due to a power failure or the removal of the power cord. The current time needs to be reset.

If the power-economizing mode (page 7) is on, all the display lights turn off when the power is turned off. To view the clock, press II so that the time is displayed for 4 seconds.

The unit can be turned off automatically at a specified time.

Use the remote control.

1 Press SLEEP while pressing SHIFT on the remote control.2 Within 4 seconds, turn MULTI JOG or press ++or -to specify the time until the power is turned off.

The time changes between 5 and 240 minutes in 5-minute steps.

Specified time

To check the time remaining until the power is turned off Press SLEEP once while pressing SHIFT. The remaining time is

displayed for 4 seconds.

To cancel the sleep timer

Press SLEEP twice while pressing SHIFT so that %.LEEPoFF appears on the display.

18 ENGLISH