Sony Z-L30 Inserting batteries, When to replace the batteries, To turn the unit on, Flash window

Inserting batteries

Detach the battery cover on the rear of the remote control and insert two R6 (size AA) batteries.

R6(AA)

When to replace the batteries

The maximum operational distance between the remote control and the sensor on the main unit should be approximately 5 meters (16 feet). When this distance decreases, replace the batteries with new ones.

To use SHIFT on the remote control

Buttons @ have two different functions. One of these functions is indicated on the button, and the other on the plate above the button.

To use the function on the button, simply press the button.

To use the function on the plate above the button, press the button while pressing SHIFT.

To use FUNCTION on the remote control

FUNCTION substitutes for the function buttons (TAPE, TUNER/ BAND, PHONO, VIDEO/AUX, CD) on the main unit.

Each time FUNCTION is pressed, the next function is selected cyclically.

●If the remote control is not going to be used for an extended period of time, remove the batteries to prevent possible electrolyte leakage.

●The remote control may not operate correctly when:

-The line of sight between the remote control and the remote sensor inside the display window is exposed to intense light, such as direct sunlight

-Other remote controls are used nearby (those of a television, etc.)

To turn the unit on

Press one of the function buttons (TAPE, TUNER/BAND, PHONO, VIDEO/AUX, CD). Playback of the inserted disc begins, or the previously tuned station is received (Direct Play Function). pOWER is also available.

To turn the power off

Press POWER.

Illumination guide

Whenever POWER or one of the function buttons is pressed, the buttons for the selected operation light up or flash.

Flash window

The window on the top of the unit lights up or flashes while the unit’s power is on.

To turn off the light of the top window, press ■ while pressing CD. To turn back on, repeat the above.

m

When you press CD to turn on/off the flash window, the BLANK SKIP PLAY is also switched to ON/OFF.

To chanae the bricihtness level of the dis~lav

1 Press~CO so th;t “ECOMODE” is display~d. -

2Within 4 seconds, turn MULTI JOG to display “DIMMODE”, and then press ENTER within 4 seconds.

3Within 4 seconds, turn MULTI JOG to select the dimmer mode as below.

The mode will be automatically set after 4 seconds. It will also be set if ENTER is pressed within 4 seconds after step

~DIM-OFF+DIMMER I++ DIMMER 2-DIMMER3~

DIM-OFF: The normal display.

DIMMER 1: The illumination of the display is dimmer than usual.

DIMMER 2: The illumination of the display is dimmer than DIMMER 1.

DIMMER 3: The illumination of the display is dimmer than DIMMER 2. The spectrum analyzer, the window on the top of the unit, and the button lamps light off.

6 ENGLISH