The unit can be turned on at a specified time every day with the built-in timer.

Preparation

Make sure the clock is set correctly.

1 Press one of the function buttons to select a source.2 Press TIMER to display @ and U PLAY.

When using the remote control, press TIMER while pressing

SHIFT.

Time and audio source name flash alternately.

3 Within 6 seconds, turn MULTI JOG to designate the timer-on time, then press ENTER or II.

Turning MULTI JOG changes both the hour and the minute.

+or - is also available instead of MULTI JOG. Holding these buttons down will vary the time rapidly.

4 Within 4 seconds, turn MULTI JOG to select the duration for the timer-activated period.

The duration can be set between 5 and 240 minutes in 5- minute steps.

● + or - is also available instead of MULTI JOG.

The duration will be automatically set after 4 seconds. It will also be set if ENTER or I I is pressed within 4 seconds after step 4.

5 Adjust the volume.

The source sound will play at the volume level set in this step when the power is turned cm by the timer.

If the volume level is set to 21 or higher, however, it will automatically be set to 20 when the power is turned on.

6 Prepare the source.

To listen to a CD, load the disc to be played first on tray 1. To listen to a tape, insert the tape into deck 1 or 2.

To listen to the radio, tune into a station.

7 Press POWER to turn off the power.

@remains on the display after the power is turned off (timer standby mode) if the power-economizing mode is OFF.

8 Get ready for the TAPE function or the timer recording.

To listen to the tape, press > on Deck 1 or 2.

To record the source, insert the tape into Deck 1 and press

●on Deck 1.

When the timer-on time is reached, the unit turns on and begins play with the selected source.

●You can change the source that was selected in step 1 by pressing one of the function buttons before pressing ENTER

or II in step 3.

. If the power-economizing mode is ON, 0 is not displayed in the timer standby mode.

The timer recording period and tape length

When the length of the tape to be recorded is shorter than the timer recording period, ● on deck 1 is released before the timer is off.

When the tape length is longer than the timer recording period,

●is not released. if ● is not released for a long time, the tape in the deck may be damaged. Press WA to release ●.

ENGLISH 19