Southbend SB1042PF owner manual Brake Service, Needed Qty, To replace the brake shoes

Turn-Nado®EVS Lathes S E R V I C E For Machines Mfg. Since 3/11

Brake Service

The brake linkage on this lathe is not adjustable. As pivot points wear, the increased play in

the linkage absorbs the usable stroke that is required for full brake application.

If the brake does not stop the lathe quickly, verify that the linkage is not excessively worn or damaged and that all fasteners are tight before replacing the brake shoes.

Needed:	Qty
Another Person	1
Hex Wrench 6mm	1
Hex Wrench 8mm	1
Needle-Nose Pliers	1
Basic Calipers	1
Safety Goggles	1 for Each Person
Approved Respirator	1 for Each Person

To replace the brake shoes:

1.DISCONNECT LATHE FROM POWER!

2.Put on a respirator and eye protection to protect yourself from hazardous brake dust.

3.With the help of another person, remove the splash guard. See Figure 126 for the locations of the cap screws that secure the backsplash.

Cap

Screws

Figure 126. Locations of the backsplash cap screws.

4.Remove the two cap screws that secure the chuck guard to the top of the headstock (see Figure 127), then remove the guard.

Cap	Chuck
Screws	Guard

Figure 127. Location of cap screws securing the chuck

guard.

5.If installed, remove the chuck from the spindle, then remove the brake drum cover (see Figure 128).

Brake Drum

Cover

Figure 128. Brake drum cover.

-82-