4.6 Connecting to a peripheral unit
You can connect a peripheral unit to the printer using a modular plug. The following describes how to install the ferrite core and make the actual connection. See “Modular plug” on page 31 for details about the type of modular plug that is required. Note that this printer does not come with a modular plug or wire, so it is up to you to obtain one that suits your needs.
Important!
Make sure that the printer is turned off and unplugged from the AC outlet and that the computer is turned off before making connections.
❏Affix the smaller ferrite core onto the modular wire as shown in the illustration below.
Ferrite core (20 mm diameter)
Connector Cable
Pass the fastener through the ferrite core.
5cm maximum
Fastner
– 15 –
