Star Trac 620-7920 manual For E-TRxe model only

Step 9. (for E-TRxe model only)

Route the user detect cable behind the eleva- tion motor and plug it into the user detect con- nector on the left side of frame.

Note: This user-detect cable is only available on the E-TRxe model. If your unit is not equipped with an embedded display; then skip this step.

Step 11.

Once the display frame is in place, fasten it to the neck using the 1/4” Hex key with (2) 5/16-18 x 1.0” socket head screws, (2) 5/16 washers and (2) lock washers. DO NOT fully tighten yet.

9

Step 10.

Now install the top display rail. Align the rail’s mounting holes with the neck holes.

Note: If the electronic display console was assembled to the rail; remove the screws holding it to the rail and store the display for later use.

Hint: If one person is assembling the unit, insert two 5/16 screws into top rail holes and use them to align and temporary hold the rail while you secure it from the back.

Step 12.

Identify left and right handrails by the part number affixed on the bottom of rails. (left rail’s part number is 020-7179, and right rail’s part number is 020- 7181).

Assemble handrail joint as shown. DO NOT fasten the (2) #10 button head socket screws in the upper handrail joints until both handrails are in place.

620-7920 Rev A