Sterling BF3-600 specifications DP30

DP30 050940	P050940	0.2 Rev./min	15.64 g/Rev.	0.41 lb/hr	13.20 lb/hr	19.53 g/Rev.	0.51 lb/hr	16.50 lb/hr
	# of Holes	6.4Rev./min	0.39 g/Hole	0.187 kg/hr	6.00 kg/hr	0.49 g/Hole	0.23 kg/h	7.50 kg/h
		(6.4 RPM)
	Diameter
	Disc Thickness	0.5 Rev./min		1.00 lb/hr	22.62 lb/hr		0.12 lb/hr	28.65 lb/hr
		11.5 Rev./min		0.45 kg/hr	10.62 kg/hr		0.57 kg/hr	13.80 kg/hr
		(11.5 RPM)
Default		1.0 Rev./min		2.00 lb/hr	73.40 lb/hr		2.60 lb/hr	91.70 lb/hr
Calibration #
		35.5 Rev./min
15.00 g/rev				0.94 kg/hr	33.30 kg/hr		1.17 kg/hr	41.60 kg/hr
		(35.5 RPM)
DP30 250940	P250940	0.2 Rev./min	7.82 g/Rev.	0.20 lb/hr	13.2 lb/hr	9.76 g/Rev.	0.26 b/hr	8.25 lb/hr
	# of Holes	6.4Rev./min	0.20 g/Hole	0.093 kg/hr	3.00 kg/hr	0.245 g/Hole	0.115 kg/h	3.75 kg/h
		(6.4 RPM)
	Diameter
	Disc Thickness	0.5 Rev./min		0.46 lb/hr	10.55 lb/hr		0.60 lb/hr	13.57 lb/hr
		11.5 Rev./min		0.21 kg/hr	4.78 kg/hr		0.27 kg/hr	6.15 kg/hr
		(11.5 RPM)
Default		1.0 Rev./min		1.00 lb/hr	36.70 lb/hr		1.30 lb/hr	45.85 lb/hr
		35.5 Rev./min
Calibration #				0.47 kg/hr	16.65 kg/hr		0.58 kg/hr	20.80 kg/hr
		(35.5 RPM)
7.80 g/rev

Note 1: This guide is to be used for general disc selection for Digital Dosing unit applications. All rates shown are continuous throughput and are based on free-flowing materials. Consult factory for regrind, powder and all hard to flow materials.

Note 2: Maximum feeder disc revolutions in one screw recovery period (injection mode) is 9.5 revolutions. Use proper disc sizing for injection mode applications to ensure proper dispense of material during the recovery cycle. Maximum dispense during a recovery cycle should not exceed 9.5 revolutions of the metering disc.

57