Step | Sterling BF3-600 specification

•Press a third time.

•The machine displays a flashing , “g” or “lb” and a number “4”flashes on the display (because this is Extrusion Constant, step 3 is skipped).

•After the “4” flashes on the display, a number in the format xxxx.x will come up.

•Enter the calibration weight. If the calibration weight is unknown, enter “00.00” and complete the calibration procedure (section 3.6) to obtain the correct value. Upon completion of the calibration procedure, the calibration weight will automatically be updated into the recipe. The range of values that can be entered in this field is 00.00 to 400.0.

Step 4:

•Press again. This will activate the printing option if it is available and the number “6” will be displayed.

•After the “6” flashes on the screen, a number in the format xxx.xx will come up on the display.

•By using the arrow keys, you can choose your printer parameters. If you have not activated this option, skip to the next step.

Digital Dosing Units

21

Image 22

Sterling BF3-600 specifications Step

Contents

SDD Digital Dosing Units Parts and Service Department Table of Contents Introduction Station Digital Dosing Unit I C K A R T G E S V E U E R D E R Controller Touch Keypad Keys and Symbols Symbols Unpacking Recipe Setup For Injection MoldingQuick Start-up Mounting Recipe Setup For Extrusion Calibration I C K A R T G E S V E U E R D E R Initial Installation And Operation Initial Installation Electrical diagram of connections Electrical Diagram Diagram of frequency inputs Initial Operation Recipe Input Injection Molding Injection MoldingStep Step Step Step Operation-Injection Molding Extrusion Constant Recipe Input Extrusion Constant Step Step Operation -Extrusion Constant Extrusion Proportional Recipe Input Extrusion Proportional Step Operation -Extrusion Proportional Calibration Determining the Calibration Weight Repeat steps 3 and 4 four 4 more times Digital Dosing Units Recipe Storage And Recall Advanced Operations/ Control FunctionsRecipe Storage Recipe Recall Clearing The Totalizer Acknowledging AlarmsOptional Equipment Alarms Level Probes Mixer Euromap E17 Interface Removing the Scraper MaintenanceMaintenance Intervals Removing the scraper Installing the scraper Cleaning the Digital Dosing Dosing StationDismantling the Dosing Station Installing the Dosing Station Installing the Dosing Disc Removing the Dosing Disc Installing Different Types of Dosing Discs Removing/Replacing the Scraper in the DT Dosing Station Cleaning the DT Dosing Station Exchangeable Stations Replacing Fuses See Appendix D on page 61 for fuse part numbers General Troubleshooting Unit Will Not Operate Appendix a TroubleshootingMalfunctions or Errors Error Codes Error Codes Injection Molding Determining the Software Setup FactorRecipe Formulas Extrusion Recipe Limitations Extrusion Extrusion Mode Appendix B Basic Parameter SettingsMax. input frequency = Hz Determining the Configuration Value Extrusion Constant or Proportional Probe Digital Dosing Units Basic Parameter Settings Digital Dosing Units Digital Dosing Units Disc Dosing Factor Disc Guide D30-051725 DT30-102025 DP30 Specification Sheet Disc Dosing Factor Table Digital Dosing unit parameter setup Page Station 1 Digital Dosing Unit Station 2 Digital Dosing Unit Side View TOP View Dosing Unit Electrical Schematic Chart Appendix D Spare Parts List Dosing Disc/Shear Order NumbersPage Parts Department Service DepartmentTechnical Assistance Sales Department