SERVICING INSTRUCTIONS

REPLACING PARTS

1.GENERAL

1.1All main components can be replaced without removing the appliance from its installation. It is essential that the gas supply to the appliance is turned off at the isolation device before proceeding further.

1.2DISCONNECT BATTERIES BEFORE SERVICING THE

APPLIANCE

1.3Removal of Flue

If, for any reason, the flue has to be removed from the appliance, the seal must be replaced in the inner spigot.

1.4Access to the controls is restricted and the whole of the control assembly is to be removed as one unit. Refer to

Section 7 below

2.DECORATIVE FRAME

2.1The same method is used to remove each frame.

Lift the frame upwards off the four support brackets,

Diagram 1

1

AR2136

NOTE: THE STEEL FRAME IS HEAVY. TAKE CARE WHEN LIFTING

3.WINDOW FRAME ASSEMBLY

3.1Using the allen key provided to release the upper and lower catches on the right side of the door:

Slide the allen key into the gap between the door and frame and locate the catch of the upper lock

Push the allen key DOWN

Slide the allen key into the gap and locate the lower lock

Push the allen key UP

Open the door outwards

When closing the door ensure the door catches are fully engaged.

2

AR2119

3.2To completely remove the glass front:

Open the door at a right angle to the fire

Lift the door vertically off its hinges and place to one side, Diagram 3

3

AR2137

Refit in reverse order

Refit in reverse order

4.GLASS WINDOW

4.1Remove the two clips and brackets from either side of the frame, Diagram 4

4

AR1864

Lift the glass clear from the lock bracket at the top of the frame and slide out

31

Page 31
Image 31
Stovax Studio 22 manual Replacing Parts, General, Decorative Frame, Window Frame Assembly, Glass Window