Subaru Robin Power Products EH12-2, EH17-2, EH25-2 manual do not abruptly put off your

(3)Tightening the set-screw.

-1i Push the latchet-guide lightly by hand so that

thelatchetguidewon’tmoveandtightenthe set-screw.

(4)Storing the spring-power.

-1:Holdthecasetightandusingbothhands,

wind up the reel counter-clockwise 6 times.

-2: Set thereetokeeptheposition,wherebythe rope hole of the reel and the rope guide make a direct line. (Fig. 9-7)

Fig. 9-7

WARNING

The spring power is at its most when the reel is being wound. Therefore, hand nor loosen the pressure of your finger unintentionally.

( 5 ) Setting the rope. ( 2 persons required)

-1:Set the end of the rope through the rope guide and the rope hole of 20 cm outof the reel. (Fig. 9-7)

-2 :Fasten the endof the rope.

do not abruptly put off your

the reel and pull the end about

ABOUT

20mm

F;g. 9-8

-3 :Put the rope into the reel, whereby make sure that the rope willnot float up. (Fig. 9-9)

-4:Holdtheropefirmlywithonehandatthe

position about 50 cm from the rope guide and keep the rope slightly pulled so that the rope will not be wound in.

-5 :Putthehand off thereelgentlyandputthe rope back slowly obeying the winding power of thespring until theknobreachestherope guide.

Assembly is complete.

Fig. 9-9

- 52 -