Subaru Robin Power Products EH12-2, EH17-2, EH25-2 manual Starting System, Recoil Starter

9.STARTING SYSTEM

9-1RECOIL STARTER

Equipments to be prepared : Driver, Pinchers (Pliers) and Protective Glasses

WARNING

starting the disassembly; make sure to wear the protective glasses.

9-1-1Disassembly Steps

(1)Setting off the spring power

-1:Hold the starterknob and extractthestarter rope.

-2 :Extractthe rope fullyand hold therope so that the knob of therope in thereelmakesa dicrect line with the rope guide.

-3 :Pushand holdthereel withthethumbs of both hands firmly so that the rope will not be wound back. (Fig. 9-1)

-4 : Pull off the knot of therope out of thereel, unfastenthe knot and pull it off tothedirec-

tion of the starter knob.( 2 persons required)

-5 :By controling the reel with the thumbsof both hands,unwindtheropegentlyuntiltherota- tion of the reel stoos.

1I/

I

Fig. 9-1

r

The spring power is at its mostwhen the rope is fully extracted. Therefore,do not abruptly putoff your hand nor loosen the pressureof your finger unintentionally.

(2)Setting the attachments off (Fig. 9-2)

- 1:Fix the case and loosen the set-screw.			- e
- 2 :Put off	the set-screw, the latchetguide,the			SET SCREW
friction	springandthelatchet	in thesame
order from above.				RATCHET
(3) Setting the reel off (Fig. 9-2)				GUIDE
- 1:Push the reel lightly so that it		will not float		FRICTION
up.Movethereelclockwiseandcounter-				SPRING
clockwiseaboutaquartercircleforseveral				RATCHET
times until it moves smoothly.
- 2 :Pull up the reel gradually and slowly and put				'REEL
it off from the case.
- 3 : In case the spring in the reel is close to pop
up, redo the steps of (3)-1and (3)-2 again.

-WARNING

Do not dropor shake the reel and putit on a level table because thereis a spring set in the disassembled reel.

Disassembly is complete.

Fig. 9-2

-50