Sun Microsystems 2000E installation manual Tools Required

1

!

!

1.3 Tools Required

Warning – This equipment contains lethal voltages. Accidental contact can result in serious injury or death.

Caution – Improper handling by unqualified personnel can cause serious damage to this equipment. Unqualified personnel who tamper with this equipment may be held liable for any resulting damage to the equipment.

Persons who remove any of the outer panels to access this equipment must observe all safety precautions and ensure compliance with skill level requirements, certification, and all applicable local and national laws.

All procedures contained in this document must be performed by qualified service-trained maintenance providers.

Caution – Before you begin, carefully read each of the procedures in this manual. If you have not performed similar operations on comparable equipment, do not attempt to perform these procedures.

The following list represents the minimum of tools and test equipment required to service the system cabinet:

•Screwdriver, slotted, 3/16 inch

•Screwdriver, Phillips #2

•Screwdriver, Phillips #1

•Hex driver, M-4

•Hex driver, 3/16 inch

•Hex driver, 9 mm

•Wrench, 13 mm

•DIP/IC extraction tool

•ESD mat, Sun P/N 250-1088, or equivalent

•Grounding wrist strap

•Needlenose pliers

1-4 SPARCserver 2000E Power Supply Installation Manual—April 1995