Sun Microsystems 2000E installation manual DC power green Fault yellow System running green

2

Note – The following screen display is an example only. The actual message displayed on the screen will vary with the software running on the system.

<<<<SPARCsystem 2000XX POST VX.X >>>>

...(various test messages)...

SPARCsystem 2000 Series (2 X XXXXXX),		No Keyboard
ROM Rev. -.-, --- MB Memory	installed, Serial #		---.
Ethernet address -:-:--:-:--	:--, Host	ID: ------	.

Note – When a system is started for the first time, or if the master board is replaced, OBP will prompt you to select a system board to be the new system master. The system master is normally in slot 0.

If there is no terminal on this system, you must check the system status by inspecting LEDs on the front panel and if present) on the power supply adapter board. See Figure 2-22 and Figure 2-23.

Table 2-1 summarizes LED status conditions during and after POST.

DC power (green)

Fault (yellow)

System running (green)

Figure 2-22Front Panel Status LEDs

2-24 SPARCserver 2000E Power Supply Installation Manual—April 1995