Sun Microsystems 2000E installation manual Power Supply Physical Installation, Filter Cable

2

Filter Cable

1.Free the filter cable.

a.On the inside of the power supply cage, cut the tie wrap and uncoil the cable. See Figure 2-8.

b.Pass the cable connector through the rectangular hole in the power supply cage and allow it to hang.

Filter cable

Tie wrap

Rectangular hole (hidden)

Figure 2-8Freeing the Filter Cable

2.5.2.2Power Supply Physical Installation

1.Install the springfingers, Part No. 340-2415-xx (two each — included with the kit) on the new power supply.

Install each springfinger (shown in Figure 2-9) using three screws.

2.Place the supply on the power supply shelf at a slight angle so the left- edge enters the power supply cavity first.

Power Supply Installation 2-9