Sun Microsystems 2000E Power Supply Sense Cable, Plug it into J1 near the top of the supply

2

2.5.2.6Power Supply Sense Cable

1.Remove the jumper-connector from the power supply adapter board. You will find this device plugged into the connector nearest the outside edge of the cabinet. Remove it. See Figure 2-18.

2.Plug the sense cable for the bottom power supply into the power supply adapter board.

Plug it into the near-most connector — from which the jumper-connector was removed in Step 2.

3.Plug the other end of the sense cable into the sense connector on the bottom power supply.

Plug it into J1 near the top of the supply.

Power supply adapter board

Jumper connector: Remove to allow the lower power supply cable sense cable to be plugged into this connector.

Power supply sense cable for bottom power supply

Figure 2-18Removing the Jumper-Connector and Installing the Sense Cable

2-18 SPARCserver 2000E Power Supply Installation Manual—April 1995