Sun Microsystems 816-7727-10 manual Install the Cable Management Arm, Not supplied in kit

Install the Cable Management Arm

This procedure describes how to attach the cable management arm to a server that is already installed in a cabinet.

You need the following components from the ship kit and the rackmounting kit to install the cable management arm and to connect the cords and cables:

■Cable management arm

■Ethernet (RJ-45) cable

You also need two AC power cords, which are not supplied.

AC power cords (2)

(Not supplied in kit)

Ethernet RJ-45 cable

Cable management arm

1.Loosen the four screws that secure the system to the left and right vertical rails at the front of the cabinet.

2.Slide the server smoothly out of the cabinet about 3 inches (7.62 cm).

Sliding the server out of the cabinet enables easy access to the areas where you will attach the cable management arm.

3.Attach one end of the cable management arm to the inner glide.

20 Sun Fire V440 Server Installation Guide • July 2003