
SUPERSERVER
5-5 Installing Memory
Note: Check the Supermicro web site for recommended memory modules.
CAUTION
Exercise extreme care when installing or removing DIMM modules
to prevent any possible damage.
Installing DIMMs
1.Insert the desired number of DIMMs into the memory slots, starting with slot
2.Insert each DIMM vertically into its slot. Pay attention to the notch along the bottom of the module to prevent inserting the DIMM module incorrectly (see Figure
3.Gently press down on the DIMM module until it snaps into place in the slot. Repeat for all modules
Memory Support
The
Note: Memory speed support depends on the type of CPU used.
Figure 5-3. Installing DIMM into Slot
To Install: Insert module vertically and press down until it snaps into place. Pay attention to the alignment notch at the bottom.
To Remove:
Use your thumbs to gently push the release tabs near both ends of the module. This should release it from the slot.
Notch
Release Tab
Notch
Front View
Note: Notch should align |
|
with the receptive key |
|
point on the slot. | Release Tab |
|
Top View of DDR3 Slot