SUPERSERVER
IPMB
A System Management Bus header for IPMI 2.0 is located at IPMB. Connect the appropriate cable here to use the IPMB I2C connection on your system.
DOM Power Connector
A power connector for SATA DOM (Disk_On_Module) Devices is located at JWF1. Connect the appropriate cable here to provide power support for your DOM devices.
UID Buttons
There are two Unit Identification (UID) buttons on the serverboard. The Front Panel UID Switch connects to pin 13 of JF1. The Rear UID Switch (SW1) is located next to the last LAN port. Pushing the UID switch on the Front Control Panel will illuminate both the Rear UID and the Control Panel UID indicators. Push the either switch again to turn off both indicators. These UID indicators provide easy identifica- tion of a system that may be in need of service.
LAN (Ethernet) Ports
Two Ethernet ports (designated LAN1 and LAN2) are located beside the VGA port on the I/O backplane. A dedicated IPMI LAN port is also located above USB1. These ports accept RJ45 type cables.
IPMB
Pin Definitions
Pin# Definition
1Data
2Ground
3Clock
4No Connection
DOM PWR
Pin Definitions
Pin# Definition
1+5V
2Ground
3Ground
