SUPER MICRO Computer 1.0a user manual Adding PCI Cards, PCI Expansion Slots, PCI Card Installation

SUPERSERVER 6016T-6RFT+/6016T-6RF+ User's Manual

5-6 Adding PCI Cards

PCI Expansion Slots

The X8DTU-6TF+/X8DTU-6F+ has one Universal PCI slot. Riser cards installed to the system allow you to add PCI expansion cards (see below). The SC819TQ- R700U chassis can support the use of two standard size (full-height, full-length) expansion cards and one low-profile (5.6" length) expansion card (with pre-installed riser cards).

PCI Card Installation

Before installing a PCI add-on card, make sure you power off the system first. Begin by removing the top chassis cover. Two riser cards should be pre-installed into the system. Remove the screws that secure the riser cards to the rear of the chassis then lift the riser card assembly from the chassis. Insert the PCI card into the riser card slot, pushing down with your thumbs evenly on both sides of the card - note that the add-on card attaches to the riser card with a single screw. After the card has been installed, reinsert the riser card back into the expansion slot on the board, then secure it with the same screws you removed previously. Finish by replacing the chassis cover.

PCI Slot/Card Configurations

Riser Card

RSC-R1UU-2E8 (left side)

RSC-R1UU-E8R+ (right side)

Expansion Card Supported

1x UIO card and 1x PCI-E x16 card

2x low-profile PCI-E x8 cards

5-12