SUPER MICRO Computer 6012L-6 user manual 95h

	Appendix B: AMIBIOS POST Codes
Checkpoint	Code Description
95h	Initializing the bus option ROMs from C800 next. See the last page of
	this chapter for additional information.
96h	Initializing before passing control to the adaptor ROM at C800.
97h	Initialization before the C800 adaptor ROM gains control has com-
	pleted. The adaptor ROM check is next.
98h	The adaptor ROM had control and has now returned control to BIOS
	POST. Performing any required processing after the option ROM
	returned control.
99h	Any initialization required after the option ROM test has completed.
	Configuring the timer data area and printer base address next.
9Ah	Set the timer and printer base addresses. Setting the RS-232 base
	address next.
9Bh	Returned after setting the RS-232 base address. Performing any
	required initialization before the Coprocessor test next.
9Ch	Required initialization before the Coprocessor test is over. Initializing
	the Coprocessor next.
9Dh	Coprocessor initialized. Performing any required initialization after
	the Coprocessor test next.
9Eh	Initialization after the Coprocessor test is complete. Checking the
	extended keyboard, keyboard ID, and Num Lock key next. Issuing the
	keyboard ID command next.
A2h	Displaying any soft errors next.
A3h	The soft error display has completed. Setting the keyboard typematic
	rate next.
A4h	The keyboard typematic rate is set. Programming the memory wait
	states next.
A5h	Memory wait state programming is over. Clearing the screen and
	enabling parity and the NMI next.
A7h	NMI and parity enabled. Performing any initialization required before
	passing control to the adaptor ROM at E000 next.
A8h	Initialization before passing control to the adaptor ROM at E000h
	completed. Passing control to the adaptor ROM at E000h next.
A9h	Returned from adaptor ROM at E000h control. Performing any
	initialization required after the E000 option ROM had control next.
Aah	Initialization after E000 option ROM control has completed. Displaying
	the system configuration next.
Abh	Uncompressing the DMI data and executing DMI POST initialization
	next.
B0h	The system configuration is displayed.
B1h	Copying any code to specific areas.
00h	Code copying to specific areas is done. Passing control to INT 19h
	boot loader next.

B-7