SUPERSERVER 6012L-6 Manual
Floppy Drive | Control Panel | RJ45 Serial Port | |||
| SCSI Drives | NMI System Reset | Main Power USB Ports | ||
Mouse Port | Keyboard Port | Ethernet Ports | Standard Size PCI Slot | ||
USB Ports COM1 Port | VGA Port |
|
| Ext. SCSI Port | |
Figure 6-1. Chassis: Front and Rear Views
6-2 Control Panel
The control panel (located on the front of the chassis) must be connected to the JF1 connector on the motherboard to provide you with system status indications. A ribbon cable has bundled these wires together to simplify the connection. Connect the cable from JF1 on the motherboard to the appro- priate header on the Control Panel PCB (printed circuit board). Make sure the red wire plugs into pin 1 on both connectors. Pull all excess cabling out of the airflow path.
The control panel LEDs inform you of system status. See "Chapter 3: System Interface" an explanation of the control panel buttons and the Onboard Indicators section in Chapter 5 for details on the motherboard LEDs. Details on JF1 can be found in "Chapter 5: Advanced Motherboard Installation."
