Tally Genicom 9316 manual Do not use label sheets that

Because the envelopes pass through heated rollers, the gummed area on the flaps may seal. Using envelopes with emulsion-based glue avoids this problem.

Note

Print envelopes on the front address side only. Some parts of the envelope consist of three layers of paper—the front, back, and flap. Anything printed in these layered regions may be lost or faded.

8 Recheck the paper guides to make sure they are adjusted to the width of the envelopes.

Note

Improperly adjusted guides may cause poor print quality, media jams, or printer damage.

9 Print the envelopes.

10 Open the flap of each envelope immediately (before it cools) after the envelope is delivered to the output tray.

How ￿￿do I load and print labels?

A label consists of a face sheet (the printing surface), adhesive, and a carrier sheet:

The face sheet must follow the plain paper specification.

￿The face sheet surface must cover the entire carrier sheet, and no adhesive should come through on the surface.

You can print continuously with label paper. However, this could affect the media feed, depending on the media quality and printing environment. If problems occur, stop the continuous print and print one sheet at a time.

Format label data within your application. Try printing your data on a plain sheet of paper first to check placement. Check your application documenta- tion for other information on printing labels.

Do not use label sheets that

Have labels that easily peel off

Labels may stick to the fuser, causing them to peel off and media jams to occur.

Printing on Media 27