Overview

TS690R Installation Manual

 

 

Overview

Introduction

The TS690R wireless alarm control system has been designed to suit small to medium installation sites. The system can monitor 30 wireless zones and 8 conventional zones via remote keypads or LECs.

The TS690R is designed to meet the requirements of BS6799 class "III" and complies with all current NACOSS codes of practice for domestic and small business audible ONLY intruder alarm systems. The system can be certificated by approved installers as a Wirefree "Class III" installation.

The radio operating frequency between the control panel receiver and the detectors is 418MHz with a bandwidth of 200kHz. The radio section is approved to MPT 1340.

Control Panel

The control panel is the controlling unit for the system, it has a power supply and connections for a standby battery. It has the following facilities:

λOn board keypad

λ8 character Starburst LCD display

λBell and strobe outputs

λ3 programmable outputs

λExtension loudspeaker output

λPrinter output

λAll system program information and the 150 event log is stored in a removable non-volatile memory (NVM)

λ10 user codes + engineer's code

λ2.1Ah battery capacity

Jamming Detection

The TS690R features a radio jamming detection option which can be enabled or disabled (see "System Configuration" on page 31. When enabled the control panel monitors for other radio signals on the same frequency used by the detectors. If the control panel detects a continuous signal for more than 30 seconds the control panel will raise an alarm. In the unset state

the alarm causes the internal sounders to beep every minute and the display shows "JAMMED". In a full or part set state a full alarm is generated.

Wireless Detectors

The TS690R uses the Scantronic 500 series range of wireless detectors. The following devices are available:

502r Watch Pendant PA

The 502r watch pendant is designed for use as a panic alarm for the TS690R. The 502r comprises a plastic waterproof case that can either be worn on a strap round the wrist, round the neck as a pendant or clipped to a pocket.

509r Fire Detector

The 509r fire detector sends a signal to alarm panel when it detects the presence of smoked.

515r Passive Infra Red

The 515r Passive Infra Red (PIR) is an indoor detector which has a 10 metre range.

525r Remote Setting Device

The 525r remote setting device can be used to set, unset and part set the alarm system. In addition, pressing the "ARM" and "OFF" at the same time will cause a panic alarm.

535r Universal Transmitter

The 535r universal transmitter sends a signal to alarm panel when the associated magnet moves away from the case, and sends a restore signal when the magnet is re-aligned. If required, you can wire external normally closed devices (e.g. 20mm flush contacts) to the 535r.

Remote Keypads

Up to 4 remote keypads can be connected to the control panel. Each remote keypad has two hard wired detection circuits and a single switched -ve output. There are two types of remote keypads that can be used:

4