Engineer’s Menu 1

TS690R Installation Manual

 

 

2.Press [A] to select the add/cancel devices option.

3.Press [C] to remove an existing device.

4.The display will prompt you to enter the device number (01 - 30). Enter the device number and press [ENT]. The control panel will give a rising multi-tone sound.

5.If required, repeat from step 3 for other devices or press [ESC] to leave this programming option.

E / MENU 1

A

ADD / CANX

C= Cancel devices

DEV ? --

Enter the device number 01 - 30.

Cancel Devices Flowchart

Re-Map Keypad Circuits

This option allows the engineer to re-map the remote keypad circuits. By default all wirefree devices are allocated to circuits 01 - 30 and remote keypad circuits are allocated to circuits 31

-38. Using this option it is possible to re-map the remote keypad circuits to circuits 01 - 30. For example if your system of only uses 10 wirefree detectors and one remote keypad, you can re-map circuits 31 and 32 (remote keypad 1) to circuits 11 and 12 so that the circuit numbering remains sequential.

E / MENU 1

C

MAP? --

Enter device No (31 - 38)

e.g. 31

MAP? 31

The display shows the

current mapping.

Enter new circuit No.

e.g. 11

TO 11

Re-Map Keypad Circuits Flowchart

Wirefree detectors cannot be mapped to circuits 31 to 38. To re-map a wirefree detector it must be cancelled from the system and then relearnt to a new device number.

34