TS690R Installation Manual

System Installation

 

 

525r Remote Setting Device

 

 

Activity LED

PANIC

ARM

 

NIGHT

Part set button

 

 

OFF

 

5

The 525r remote setting device can be used to set, part set (part set A only) and unset the alarm system. In addition, pressing the "ARM" and "OFF" at the same time will cause a panic alarm. The 525r is assigned as a detection circuit.

Learning

See "Adding Devices" on page 33.

Changing the Battery

The battery used in the 525r is a Duracell DL 1/3N or CR 1/3N or K58L (Alkaline). The battery can be obtained from normal high street stockists.

1.Undo the screw holding down the battery compartment cover.

2.Slide back the cover.

3.Replace the battery (make sure the battery polarity is correct).

4.Replace the cover and tighten the screw.

-ve Terminal

Battery +ve Terminal

Installing a 535r Universal Transmitter

Activity LED

The 535r universal transmitter is designed to work with the TS690R control panel. The transmitter signals an alarm when the associated magnet moves away from the case, and sends a restore signal when the magnet is re-aligned.

Terminal

 

 

Block

Internal Reed

 

 

 

Internal

Shunt Link

 

 

 

Reed

 

 

Fixing

 

Battery

Hole

+

Case

 

 

Tamper

 

 

Bar

 

Tamper

 

 

+

Fixing

Hole

Back

Body

Siting the 535r Universal Transmitter

Where possible, mount the unit close to the top of the non-moving frame of a door or window, and the magnet on the moving part. If the frame is not wide enough, mount the magnet on the frame and the unit on the moving part.

17