The iDP™ Display - Master
EXIT
ENTER
INTERACTIVE DIGITAL PROGRAMMING |
ENTER key
The ENTER key has two main functions: 
To enter the menus currently displayed.
To set the displayed parameter in Edit mode.
When a parameter can be edited via the CURSOR keys a “H “ is set as the first character in front of the parameter.
EXIT key
The EXIT key is used to exit the current display and go to previous menu level.
CURSOR UP/DOWN key
These keys are used for navigating and adjusting parameter values.
The previous page illustrates how to navigate through parameters using the iDP™ display.
Setting up - Introduction
To make your setup operate as intended correct cabling is essential. Choose one of the described setups and connect exactly as illustrated. The following section is a
For instructions on how to place and calibrate monitors please read pages
Setup including Subwoofer:
To activate the subwoofer, please choose an appropriate crossover frequency in the Bass Management menu. To read more about Bass management and subwoofer placement, please refer to page 28.
General Setup Procedure
Decide which Setup you are going to build.
Connect monitors exactly according to the illustrations on the following pages.
Power up all monitors.
Set one of the
This is done by leaving the TC LINK button on the rear panel on OUT position.
NOTE: There can be only ONE System Controller in a setup.
After
Set tasks for all monitors via the System Controller until via the following procedure: Enter Setup menu by pressing ENTER, ARROW DOWN, ENTER.
Select the setup type you are using.
Press ENTER again and the System will generate Pink Noise in one of the monitors. Select appropriate task for the monitor currently fed with Pink Noise using the ARROW keys and press ENTER to confirm.
Continue allocating tasks for all monitors in the system.
Your monitor system is now set up ready for calibration and
These procedures are described on pages
PLEASE NOTE: These setups will ONLY operate correctly if connected according to the illustrations!
15
