Calibrate Subwoofer | Tannoy ACTIVE STUDIO MONITORS manual

A C T I V E S T U D I O M O N I T O R S

iDP SOFT™ (cont.)

Calibrated Level

Level calibration of the selected monitor.

Relative Level

Preset volume for the selected monitor relative to the calibrated and global volume.

Use Parametric EQ

This will be marked if the Parametric EQ is activated via the PC-iP™program. Bass and Treble settings will be disabled.

Bass/Treble

Range: -6dB to +6dB. Bass and Treble adjustment for the selected monitor.

The Bass/Treble functions are not available when the Parametric EQ is activated using the PC-iP™program.

Mute

Press to mute the selected monitor.

Solo

Press to solo the selected monitor.

Pink Noise

Press to generate Pink Noise in the selected monitor.

Calibrate – Subwoofer

Parameters and settings for the Subwoofers is controlled via this screen.

The screen is accessed from the Main Screen by holding the cursor above the desired Sub and selecting the hammer icon.

40

Image 40

Tannoy ACTIVE STUDIO MONITORS owner manual Calibrate Subwoofer

Contents

Owners M a N U a L Page Important Safety Instructions Important Safety Instructions Quick Setup Guide T I V E S T U D I O M O N I T O R S Introduction Concept & Design Philosophy Tannoy Dual Concentric Unpacking & Visual Checks High efficiency compact Switched Mode Power Supply SmpsTannoy WideBand SuperTweeter Preliminary Recommendation Speaker PlacementOrientation Master & Slave Concept Remote Control Slave Monitor & SubwooferInitializing the Network IDP Soft Software Remote Master Unit Slave/Subwoofer SUB General Setup Procedure IDP Display Master General Setup Procedure SetupsAnalog Stereo Set-up With Mono Subs Analog Stereo Set-up With Stereo Subs Stereo Digital Set-up With Mono Subs Analog Set-up Digital Set-up Digital 192kHz Set-up Digital Set-up Analog Set-up Alternative 7.1 Set-up Analog, Digital& 192kHz Connecting Two Subs Connecting Three Subs Dig/6 Master Stereo Set-up With Chains on L&R. Analog or Digital Setup when the monitors are connected Reset Procedure Reset All SettingsSelect Setup Select Monitor Tasks Press Enter to access the Select Mode Parameter DescriptionMain Display † PC-iP Phase Bass ManagementLFE Low Pass Filter LFE Gain Setup Menu SetupSet Monitor Task External Clock Parameters available for the subwoofer LFE channel important Parameter Categories IDP Remote Preset 1/3 and 2/4 keys Volume potentiometerREF Level keys MUTE/UNMUTE Solo keys for the channels R LS- SUB RS Installation on PC Installation on MacIDP Soft Minimum requirements Volume Control REF LEV. keysMonitor and Sub icons Bass Mgt Bass Management IDP Soft Preset List Recall presetsStore presets Locked symbol in Preset List IDP Soft Network Upload Software to Monitors Analog Gain System Setup ConfigurationBNC Sync Monitor Assignment Calibrate Main Monitors Calibrate Subwoofer LFE Gain Range 0 to 14dB Phase RangeLFE Low Pass Filter Chained monitors Technical Specifications Precision 6 iDP System Master & Slaves Technical Specifications- Precision 8 iDP Technical Specifications TS212 iDP Subwoofer TS112 iDP Subwoofer & iDP Dimensions Precision 6 iDP Dimensions Precision 8 iDP Dimensions Precision TS212 iDP Grey/Silver Dimensions Precision TS112 iDP Grey IDP Display Messages System Delays Sample Rate Digital Input Analog Input Curves Explained SUB LFE Cables TC Link Standard Cat-5 cablesAES/EBU Standard cables Serial to Cat-5 cable Declaration Of Conformity Warranty Page Issue Software Version 1.53 Part No GH 01 December